Avaya 8300 Series Routine Maintenance page 22

Fan Tray cleaning
2. Wait 10 seconds for the fans to stop turning, and then pull the fan tray out of the
3. Vacuum the fans.
4. Slide the fan tray into the chassis until the connectors at the rear of the fan tray
5. Tighten the captive screws to fasten the fan tray to the chassis.
6. With the chassis power on, verify that the green status LED is lit.
22 Routine Maintenance
chassis.
Caution:
Grasp the fan tray at the middle of the front panel, and be careful to keep your
fingers out of the fan blades.
engage.
If the chassis is powered on, the fans start turning when the fan tray connectors are
fully engaged.
May 2011