Hdmi Connections - Extron electronics IN1804 Series User Manual

HDMI Connections

Use an Extron LockIt cable lacing bracket to secure HDMI cables to the device.
NOTE: The HDMI device must have an HDMI connection mounting screw for this
bracket to be used.
To securely fasten an HDMI cable to a device:
1
3
4
Figure 12.
1. Plug the HDMI cable into the panel connection (see figure 12,
2. Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it (
3.
Place the LockIt lacing bracket on the screw and against the HDMI connector, then tighten
the screw to secure the bracket (
4. Loosely place the included tie wrap around the HDMI connector and the LockIt lacing
bracket as shown.
5.
While holding the connector securely against the lacing bracket, use pliers or a similar
tool to tighten the tie wrap, then remove any excess length (
ATTENTION:
•
•
2
3
Mounting a LockIt Cable Lacing Bracket
).
3
Do not overtighten the HDMI connection mounting screw. The shield to which
it is fastened is very thin and can easily be stripped.
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
IN1804 Seamless Scaling Switchers • Installation
).
1
). The screw does not have to be removed.
2
).
4
17