Table of Contents
Advertisement
For each SM cable:
•
•
NOTE:
LockIt HDMI Cable Lacing Bracket Installation
The Extron LockIt lacing bracket secures a standard HDMI cable to most HDMI devices.
Follow these instructions to secure the HDMI connectors to the switcher with the provided LockIt
HDMI lacing bracket.
NOTE: The Extron HDMI device must have an
To securely fasten an HDMI cable to a device:
1.
2.
3.
4.
While holding the connector securely against the lacing bracket, tighten the tie wrap, then
remove any excess length.
ATTENTION:
Connect the red (contact) pigtail to the C pin corresponding to the input being used.
Connect the black (tally out) pigtail to the T pin.
In an SM cable, the ground source needed to trigger the contact and the
voltage to drive the tally indicator are supplied by HDMI source device. Therefore, it is
not necessary to connect the cable to a G (ground) pin.
HDMI connection mounting screw for this
bracket to be used.
Plug the HDMI cable into the panel connection (see
in the image at right).
1
Loosen the HDMI connection mounting screw from
the panel enough to allow the LockIt bracket to be
placed over it (
2
). The screw does not have to be
removed.
Place the LockIt lacing bracket on the screw and
against the HDMI connector (
screw to secure the bracket.
Loosely place the included tie wrap around the
HDMI connector and the LockIt lacing bracket as
shown at right (
).
4
Do not overtighten the HDMI connection mounting screw. The shield to which it
•
is fastened is very thin and can easily be stripped.
•
Ne serrez pas trop la vis de montage du connecteur HDMI. Le blindage auquel
elle est attachée est très fin et peut facilement être dénudé.
1
3
), then tighten the
2
3
4
3
UCS 303 • Installation
13
Advertisement
Table of Contents
