Extron electronics IN1804 Series User Manual page 42

TP 1A Mode (IN1804 DO and IN1804 DI/DO only) — This item lets you select the
•
twisted pair mode of the DTP2/XTP/HDBT output on the IN1804 DO or IN1804 DI/DO.
To switch among DTP, XTP, and HDBT modes for the TP output port, select this item

and press the or

NOTE: For the IN1804 standard and DI models this panel displays –– ––.
Mode selection is available only for the TP output (1A) on the IN1804 DO or
IN1804 DI/DO.
• HDMI 1B Format — Select this option to specify an output format for HDMI output
connector 1B. Press the
• Auto (based on the EDID of the sink) (default)
• DVI RGB 444
• HDMI RGB 444 Full
• HDMI RGB 444 Ltd
• HDMI YUV 444 Ltd
• HDMI YUV 422 Ltd
• HDMI YUV 420 Ltd*
*Available only for 3840x2160 and 4096x2160 resolutions
HDCP Notification — This item lets you select what is displayed on the HDMI output
•
when the input signal contains HDCP-protected content and the output is a non-
HDCP sink. After pressing Enter to select this item, press the
between:
Green w/OSD — Displays a green screen with the message HDCP Content on the
•
HDMI output display (default).
Black Screen — Displays a black screen and the output sync is maintained.
•
User Image — Displays a user-uploaded image. To upload images, use the PCS
•
software Logo screen (see the IN1804 Series Help File for instructions).
• User Logo — Select this item to enable or disable display of a user-uploaded logo
image. There are 16 slots available for storing logo files. To upload a logo file to the unit,
use the Logo Config page of the PCS configuration program (see the IN1804 Series
Help File for the procedures).
To select a logo to display:
Select User Logo from the Output menu and press Enter.
1.

2. Press the  or
01: Unassigned through 16: Unassigned. Use the Logo SIS commands (see
the Logos commands
PCS configuration program (see the IN1804 Series Help File) to assign a logo file to
the selected slot.
When a logo is assigned to a slot, its name changes from Unassigned to
nn:Logo n. You can change this name via SIS or PCS commands.
The default selection for this menu is Off.
3.
Press Enter to confirm your selection.
NOTE: To configure logo key effects (such as RGB keying, alpha keying, and so
on) and to key logos over live video see the IN1804 Series Help File.
buttons to select DTP, XTP, or HDBT.

and buttons to step through the format options.

button to select a logo slot. By default the logo slots are named
beginning on page 67) or the Logo Config screen of the
IN1804 Seamless Scaling Switchers • Operation

 or button to select
34