Extron electronics IN1804 Series User Manual page 19

AC power connector
A
DisplayPort input connector
B
HDMI input connectors
C
Inputs 2-4 (standard and DO models)
Inputs 2-3 (DI and DI/DO models)
Over TP IR pass-through input port
D
(DI and DI/DO models)
DTP2/XTP input connector
E
(DI and DI/DO models)
DTP2/XTP/HDBT output connector
F
Output 1A (DO and DI/DO models)
Over TP IR pass-through port
G
(DO and DI/DO models)
AC Power connector — Connect a standard IEC power cord (provided) from a
A
100 to 240 VAC, 50-60 Hz power source to this connector. The front panel button
LED for the selected input (see
30 seconds. When the unit is ready for operation, the input selection LED lights steadily.
If auto-input switching has been enabled, the Auto SW LED lights also (see
Switch on the OSD Advanced submenu on page 39).
DisplayPort input connector (input 1) — Connect a DisplayPort source to this
B
female DP connector.
HDMI input connectors — Connect HDMI video sources to these female HDMI
C
connectors. (The standard and DO models have three HDMI input connectors while the
DI and DI/DO models have two.)
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the
TIP:
device (see
Over TP IR pass-through port for input (IN1804 DI and IN1804 DI/DO only) —
D
To transmit and receive infrared data to and from a source
connected to the DTP2 transmitter or XTP matrix switcher, connect a
control device (such as an Extron IPCP Pro Control Processor) to
this 3-pole IR Over TP captive screw port (see the illustration at
right).
NOTE: RS-232 communication can also be sent to the far end
of the twisted pair connection, but it must be done through
RS-232 insertion via Ethernet. A signal sent to an IN1804
LAN port can be routed to the RS-232 port of any connected
twisted pair device (see
page 44).
H
— Input 1
—
I
J
K
— Input 4
L
—
M
N
O
P
Q
figure 16,
B
HDMI Connections on page 17).
Ethernet to RS-232 Insertion
IN1804 Seamless Scaling Switchers • Installation
HDMI mirrored output connectors
Outputs 1A and 1B (Standard and DI
models)
HDMI output connector — Output 1B
(DO and DI/DO models)
LAN connector
Reset button
Reset LED
Remote RS-232 connector
Analog audio output connector
Analog audio input connector
+V connector (for tally voltage output)
Ground pin (for contact/tally ports)
Contact/Tally ports
) on page 21) blinks for approximately
on
—
Auto
IR
IN1804
Tx, Rx, and G
Pins
G Tx Rx
IR Control
Device
11