Rear Case Assembly Replacement - Nellcor OxiMax N-65 Service Manual

Rear Case Assembly Replacement

O M N-65 Service Manual
XI AX
To replace the rear case assembly:
1. Remove the batteries from the monitor. See Prior to Disassembly on page 48.
2. Separate the front and rear case assemblies. See Separating the Front and
Back Cases on page 48.
Caution: The battery connectors (spring assemblies) at the bottom
of the SpO PCB are held in slots in the battery compartment.
2
Observe how these connectors are engaged in these slots when you
remove the SpO
battery connectors are inserted back in these slots when you
reassemble the monitor.
3. Lift the SpO PCB and User Interface from the case. See 18.
2
Figure 18: User Interface PCB and SpO
4. Discard the rear case assembly in accordance with local regulations.
PCB and User Interface PCB and ensure that the
2
Disassembly Guide
PCB Removal
2
57