Disassembly Guide
6.8 Rear Case Disassembly Procedures
This section describes the steps to disassemble the rear case assembly.
B. Rear Case Disassembly
B1. SMPS Bracket Disassembly
B1-1. SMPS Disassembly
56
a. Remove 4 screws and washers on the rear
case.
b. Separate the rear case from the rear case
assembly.
a. Remove 4 corner screws on the SMPS.
b. Disconnect the AC inlet wire and the
SMPS to Rear board DC wire, the
Battery wire and the External DC input
wire from the SMPS.
N5500 Service Manual