Convotherm OEB Series Service Handbook page 137

Service Handbook OEB/OES/OGB/OGS

Hang the assembly panel 1 left into the cutout for the front plate in the holding
slots.

Pull out all connectors X20 to X28 (when available) from Gas module 11.

Unscrew 8 knurled nuts 6 and pull the gas module 11 straight and evenly from
the distancing bolts M3 10.
Instructions: Gas module assembly

Place the gas module 11 straight and evenly onto the distancing bolts M3 10 of
the control module 4.

Screw on the 8 knurled nuts 6 and tighten.

Plug in the connectors X20 to X28 (when available).

Clip the fastening brackets of the assembly panel 1 in the holding slots 8 of the
angle 9 in the connection area opening. Slide assembly panel 1 down and place
onto the fastening bolts 7.

Screw the knurled nuts 6 onto the bolts 7, thereby fastening the assembly
panel 1.
Check:

When the green LED 25 on the front side of the gas module is blinking, it is
operating correctly.
 LED 25  see 6.1.5 Positions of the LEDs on the Controls.
1 = Assembly panel control module
2 = Fastening bolts
3 = Distancing bushes
4 = Control module
5 =
6 = Knurled nuts
control assembly
7 = Fastening bolt
on holder angle
8 = Holder slots
9 = Holder angle
10 = Distancing bolts M3
11 = Gas module
AS/11-2011 6_01e_Electronic Control Board installation_c
Page 7 / 8