Convotherm OEB Series Service Handbook page 12

Service Handbook OEB/OES/OGB/OGS
Safety Advice for Service work
Attention – Lifting or sliding unit:

Avoid damaging the power, water and drainage connections when moving the
unit.

Make sure that the unit is secured against tilting or slipping while being
moved.

Observe the weight of the unit:
Electric units
CONVOTHERM OES / OEB 6.10: 170 kg
CONVOTHERM OES / OEB 6.20: 220 kg
CONVOTHERM OES / OEB10.10: 215 kg
CONVOTHERM OES / OEB10.20: 245 kg
CONVOTHERM OES / OEB12.20: 325* kg
CONVOTHERM OES / OEB20.10: 340* kg
CONVOTHERM OES / OEB20.20: 440* kg
* = incl. loading trolley
Attention – Working in the connection area of the unit:

Work in the connection area of the unit must be carried out by a qualified
electrician in accordance with the local power supply company regulations as
well as current EU regulations.

When working in the connection area, the unit main power supply must be
shut off (an all-pole isolation switch with a minimum contact opening of 3mm
must be located close to the unit) Make sure that the unit's power has indeed
been switched off!

After servicing, a final test, according to the local and current regulations, must
be performed.
Attention – working on the unit's gas system:

Working on the gas technology in a unit can only be performed by a qualified
installer from an authorized gas supplier.

Check all connection points outside and inside the unit for sealed tightness
(with a gas detector or leakage spray).
Attention: Do not spray leakage spray on electrical components of the
ignition and flame monitoring devices!
AS/11-2011
Gas units
CONVOTHERM OGS / OGB 6.10: 170 kg
CONVOTHERM OGS / OGB 6.20: 220 kg
CONVOTHERM OGS / OGB10.10: 215 kg
CONVOTHERM OGS / OGB10.20: 245 kg
CONVOTHERM OGS / OGB12.20: 325* kg
CONVOTHERM OGS / OGB20.10: 340* kg
CONVOTHERM OGS / OGB20.20: 440* kg
* = incl. loading trolley
0_04e_Safety Advice_b
Page 2 / 2