Convotherm OEB Series Service Handbook page 134

Service Handbook OEB/OES/OGB/OGS

Hang the assembly panel 1 left into the slots of the front plate in the holding
slots.

Pull out all connectors X10 to X17 (when available) from the control module 4.

Loosen screws on 9 pole connector 5 and remove from control module 4.

Unscrew 8 knurled nuts 6 and pull control module 4 straight and evenly out
from the fastening bolts 2.
Attention: Don't lose the distancing bolts 3!
Instructions: Control module assembly

Place the control module 4 straight and evenly onto the fastening bolts 2 of the
assembly panel 1.
Attention: Make sure that distancing bolts 3 are present.

Screw on the 8 knurled nuts 6 and tighten.

Plug in connectors X10 to X17 (when available).

Plug in the 9 pole connector 5 from the operation module.

Clip the fastening brackets of the assembly panel 1 in the holding slots 8 of the
angle 9 in the connection area opening. Slide assembly panel 1 down and place
onto the fastening bolts 7.

Screw the knurled nuts 6 onto the bolts 7, thereby fastening the assembly
panel 1.
Check:

When the green LED 43 on the front side of the plate is lit or blinking, the
control module is operating correctly. (module self-checking)
 LED 43  see 6.1.5 Positions of the LEDs on the Controls.
1 = Assembly panel of control module
2 = Fastening bolts
3 = Distancing bushes
4 = Control module
5 = 9 pole connector
6 = Knurled nuts
control module assembly
7 = Fastening bolts
on holder angle
8 = Holder slots
9 = Holder angle
AS/11-2011 6_01e_Electronic Control Board installation_c
Page 4 / 8