Parameter List - YASKAWA VS-606V7 Series Instruction Manual

Coils and relays
Large size magnetic contactors
200V
Control relays
to
MY-2, -3 (OMRON)
230V
HH-22, -23 (FUJI)
MM-2, -4 (OMRON)
• Ground fault interrupter:
Select a ground fault interrupter not affected by high frequencies. To prevent
malfunctions, the current should be 200mA or more and the operating time 0.1 sec.
or more.
Example:• NV series by Mitsubishi Electric Co., Ltd. (manufactured in 1988 and
after)
• EGSG series by Fuji Electric Co., Ltd. (manufactured in 1984 and after)
• AC and DC reactor:
Install an AC reactor to connect to a power supply transformer of large capacity
(600kVA or more) or to improve power factor on the power supply side.
• Noise filter:
Use a noise filter exclusively for inverter if radio noise generated from the inverter
causes other control devices to malfunction.
(1) Never connect a general LC/RC noise filter to the inverter output circuit.
NOTE
(2) Do not connect a phase advancing capacitor to the I/O sides and/or a surge
suppressor to the output side.
(3) When a magnetic contactor is installed between the inverter and the motor,
do not turn it ON/OFF during operation.
For the details of the peripheral devices, refer to the catalog.

• Parameter List

• Addition of parameters accompanied by the upgraded software version
The parameters marked with #1 and #2 are applicable for the following upgraded
software version Nos.:
#1: Applicable for software version No. VSP 010015 or later
#1: Applicable for software version No. VSP 010020 or later
• Parameters that can be changed during operation
The parameters whose numbers are in bold can be changed during operation.
154
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Surge suppressors
Model
Surge Suppressors
Specifications
DCR2-
250VAC
50A22E
0.5µF 200Ω
250VAC
10A25C
0.1µF 100Ω
Code No.
C002417
C002482