YASKAWA VS-606V7 Series Instruction Manual page 83

Using output signals (n057, n058, n059)
Multi-function output terminal MA, MB, P1 and P2 functions can be changed when
necessary by setting parameters n057, n058, and n059.
• Terminal MA and MB functions: Set to n057
• Terminal P1 function: Set to n058
• Terminal P2 function: Set to n059
Setting Name
0 Fault
1 In operation
2 Agreed frequency
3 Zero speed
4 Frequency detection
5 Frequency detection
Overtorque detection
6
(NO contact output)
Overtorque detection
7
(NC contact output)
10 Minor Fault
11 Base blocked
12 Operation mode
13 Inverter operation ready
14 Fault restart
15 In UV
16 In reverse run
17 In speed search
Data output from
18
communication
19 PID feedback loss
Frequency reference is
20
missing
Inverter overheat prediction
21
OH3
82
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Closed when inverter fault occurs.
Closed when either FWD/REV command is input or
voltage is output from the inverter.
Closed when setting frequency agrees with inverter
output frequency.
Closed when inverter output frequency is less than
minimum output frequency.
Output frequency ≥ frequency detection level (n095)
Output frequency ≤ frequency detection level (n095)
—
—
Closed when the alarm is indicated.
Closed when the inverter output is shut off.
Closed when "LOCAL" is selected by LOCAL/REMOTE
selection.
Closed when inverter fault is not detected, and
operation is ready.
Closed during fault retry
Closed when undervoltage is detected.
Closed during reverse run.
Closed when inverter conducts speed search.
Operates multi-function output terminal independently
from inverter operation (by MEMOBUS
communication).
Closed during PID feedback loss
Closed when frequency reference is missing
Closed when overheat prediction is input. Digital
operator display is "OH3 (blinking)."
Ref page
–
–
79
–
56
56
55
55
–
–
–
–
–
–
–
–
89
109
–
–