Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1128

3.
2x
HDD Initialization Procedure
1. Items to be prepared
• PC
Be sure that the version of the Service Support Tool
that supports the host machine is installed.
<In case of using the SST >
• Crossover Ethernet cable. (In case of SST).
In case of using the USB flash drive
• USB memory
2. Preparing for the Installation of the System Software of
Host machine
1. If the PC and host machine have been started, turn
the main power OFF.
2. Connect the PC and the machine using an Cross
Ethernet cable. (In case of SST).
3. Turn ON the power of the PC.
3. Registering the system software
1. Insert the latest System Software into the PC using
the SST.
2. Start the SST.
3. Click 'Register Firmware'.
4. Select the drive where the system software has
been inserted, and click the [SEARCH] button.
5. Click the [REGISTER] button.
6. Click [OK].
4. Initializing HDD
< In case of SST >
1. Start the host machine with download mode in safe
mode.
2. Start the SST.
3. Select the model. Then, select [Single] and click
[Start].
4. Click [Format HDD].
5. Select [All], and click [Start].
6. Click [Execute Format].
7. The Format is executed.
8. Click [OK].
9. After formatting is completed, select [Shutdown/
Restart], and click [Restart].
10. Click [OK]
11. The power of the host machine is turned OFF.
12. Terminate the SST.
13. Disconnect the Cross Ethernet Cable from the
machine, and connect the user's network cable to
the machine.
<In case of USB flash drive>
NOTE:
Use the USB device registered with the system software
for this machine by using SST.
1. Connect the USB memory device to the host
machine, and start the host machine with download
mode in safe mode.
2. Press keys on the Control Panel in the order shown
below.
• [4] : Clear/Format
• [1] : Disk Format
• [0] : OK
• Press any keys
• [C] : Return to Menu
• [Reset] : Start shutdown sequence
• [0] : OK (The power of the host machine is
turned OFF automatically.)
3. Remove the USB flash drive.
4. Turn ON the main power switch.
Executing auto gradation
adjustment
When this product is installed, the machine initializes its HDD,
resetting the data used for auto gradation correction.
Therefore, execute full adjustment of auto gradation
adjustment after installing this kit to enable proper images to
be output.
1106
9. Installation