Table of Contents
Advertisement
■ Affixing the NFC Target
1
Setting after Installation
1. Connect the power plug of the host machine to the outlet.
2. Turn ON the main power switch.
3. Eenter service mode and set the value to "1".
COPIER > FUNCTION > INSTALL > NFC-USE
NOTE:
When [System Manager Information Settings] is set, it is
required to log in as a system manager in accordance with
instructions of the user administrator.
4. Select [Settings/Registration] > [Management Settings]
> [Device Management] > [Use NFC Card Emulation],
and set the item to "ON".
5. Turn OFF and then ON the main power switch.
6. When a message prompting the version update is
displayed, press [Update] and automatically update the
version of this equipment.
CAUTION:
It may take time to display the update screen. (Approx.
1 to 2 min.) During this time, do not operate the screen.
7. Check the end of the following service mode.
COPIER > DISPLAY > VERSION > PANEL
• If the end is an even number (e.g. 01.26): NFC is
not installed.
• If the end is an odd number (e.g. 01.27): NFC is
installed.
1125
9. Installation
Advertisement
Table of Contents
Troubleshooting
