Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1189

Cassette Heater Unit-41
Points to Note at Installation
CAUTION:
Points to Note When the Cassette Feeding Unit or High
Capacity Cassette Feeding Unit Is Not Installed:
Since the machine will contain heat at its bottom if this
equipment is installed, be sure to avoid installation at
locations where heat resistance is low.
CAUTION:
Marked portion:
When tightening the screws, do not tighten them too
tightly. Otherwise, there is a risk of damage and
deformation of screw holes.
NOTE:
Although pictures or illustrations used for explanation may
differ from the actual things, the procedure is the same.
Essential Items to Be
Performed Before Installation
• Turn OFF the main power of the host machine, and
disconnect the power plug from the outlet.
WARNING:
• If performing work without disconnecting the
power plug of the host machine, it may cause
electrical shock.
• If disconnecting the power plug without
turning OFF the main power, it may cause
damage of the machine.
• When turning OFF the main power, follow the below
procedure.
1. Turn OFF the main power switch of the host
machine.
2. The display in the Control Panel and the lamp of the
main power are turned off.
Points to Note when turning
ON/OFF the main power
The following message is displayed.
1. When a message prompting to turn OFF and then ON
the main power appears, turn OFF and then ON the main
power switch.
2. If a message prompting the user to update the version
appears, press [Update] to automatically update the
version of this equipment.
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host
machine is started. In the service mode ( Lv.2 ) shown
below, it is possible to set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Installation Outline Drawing
Checking the Contents
1x
NOTE:
* : Host Machine : Use 1 of them. Cassette Feeding Unit
or High Capacity Cassette Feeding Unit: Use 2 of them.
Checking the Parts to be
Installed
Cassette Heater Unit
Prepare the following parts because each part of the
Cassette Heater Unit is assigned as service part.
1167
9. Installation
1x
TP Round End ; M3x6
2x