Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1122

2.5inch/1TB HDD-P1
Points to Note at Installation
CAUTION:
• Do not use the following combination.
2.5inch/1TB HDD + Removable HDD Kit
• When handling the HDD, be careful not to vibrate
or drop it.
• If the HDD is replaced with a high-capacity HDD,
the HDD needs to be initialized.
• When replacing a HDD that contains user
information with a high-capacity HDD (which is not
an initial installation), backup and export of HDD
data are necessary. For details, refer to " Backup
Data " in the Service Manual.
CAUTION:
Marked portion
When tightening the screws, do not tighten them too
tightly. Otherwise, there is a risk of damage and
deformation of screw holes.
Essential Items to Be
Performed Before Installation
• Turn OFF the main power of the host machine, and
disconnect the power plug from the outlet.
WARNING:
• If performing work without disconnecting the
power plug of the host machine, it may cause
electrical shock.
• If disconnecting the power plug without
turning OFF the main power, it may cause
damage of the machine.
• When turning OFF the main power, follow the below
procedure.
1. Turn OFF the main power switch of the host
machine.
2. The display in the Control Panel and the lamp of the
main power are turned off.
Points to Note when turning
ON/OFF the main power
The following message is displayed.
1. When a message prompting to turn OFF and then ON
the main power appears, turn OFF and then ON the main
power switch.
2. If a message prompting the user to update the version
appears, press [Update] to automatically update the
version of this equipment.
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host
machine is started. In the service mode ( Lv.2 ) shown
below, it is possible to set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Checking the Contents
1x
Sems; M3x4
4x
Installation Outline Drawing
1100
9. Installation
1x
1x 1x
P Tightening; M3x8
2x