Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1069

● For TYPE-1 (When installing the Copy
Card Reader and the Voice Operation Kit
at the same time.)
1. Securing the Copy Card Reader Cable
1. Remove the covers of the 2 Cord Guides, and affix
the Cord Guides to the position as shown in the
figure. (Use the Cord Guides included with the
Copy Card Reader.)
2. Fold the cable of the Copy Card Reader at the [A]
part, and insert only the cable of the Copy Card
Reader through the 2 Cord Guides.
3. Install the 2 Cord Guide Covers.
2. Securing the Cable of the Voice Operation Kit
1. Remove the covers of the 7 Cord Guides, and affix
the Cord Guides to the position as shown in the
figure.
2. Insert the DVI Cable through the 7 Cord Guides,
and install the 7 Cord Guide Covers.
CAUTION:
• Do not cover the Exhaust Outlet with the Cord
Guide.
• Do not affix a Cord Guide on the Reader Cable
Cover.
9x
● For TYPE-2 (When installing the Copy
Card Reader and the Voice Guidance Kit at
the same time.)
1. Securing the Cable of the Copy Card Reader
1. Remove the covers of the 2 Cord Guides, and affix
the Cord Guides to the position as shown in the
figure. (Use the Cord Guides included with the
Copy Card Reader.)
2. Fold the cable of the Copy Card Reader at the [A]
part, and insert the cable of the Copy Card Reader
through the 2 Cord Guides.
3. Install the 2 Cord Guide Covers.
Reader
[A]
Cable Cover
Exhaust
Outlet
1047
2. Securing the Cable of the Voice Guidance
1. Remove the covers of the 4 Cord Guides, and affix
the Cord Guides to the position as shown in the
figure.
2. Fold the Speaker Cable at the [B] part, and insert
the Speaker Cable through the 4 Cord Guides.
3. Install the 4 Cord Guide Covers.
CAUTION:
• Do not cover the Exhaust Outlet with the Cord
Guide.
• Do not affix a Cord Guide on the Reader Cable
Cover.
6x
Checking after Installation
1. In service mode (Level 2), set the number of cards (the
number of departments) (1 to 1000) that can be used for
the Card Reader to any value.
COPIER > OPTION > FNC-SW > CARD-RNG
2. Enter the card number which is the smallest of the card
numbers to be used (1 to 2001) in service mode.
COPIER > FUNCTION > INSTALL > CARD
Starting from the entered card number, the number of
cards set in step 1 can be used.
3. Turn OFF and then ON the main power switch to enable
the setting value.
9. Installation
Reader
Cable Cover
[A]
[B]
Exhaust
Outlet