Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1068

15.
CAUTION:
Installing the Connector Cover
Be sure to insert the Harness Band inside the
Connector Cover.
1x
1x
1x
16.
Install the Cord Guides
CAUTION:
• Do not cover the Exhaust Outlet with the Cord
Guide.
• Do not affix a Cord Guide on the Reader Cable
Cover.
1. Remove the covers of the 2 Cord Guides, and affix
the Cord Guides to the position as shown in the
figure.
2. Fold the Card Reader External Relay Cable at the
[A] part, and insert it through the 2 Cord Guides.
3. Install the 2 covers of the Cord Guides.
2x
17.
Connect the power plug to the outlet.
18.
Turn ON the main power switch of the host machine.
■ Routing the Cable (when installing
this equipment and other options
simultaneously)
• Routing the cable when installing the Copy Card Reader
and other options simultaneously is described below.
• Combinations are shown in the following table.
Card Reader
1046
9. Installation
Reader
[A]
Cable Cover
Exhaust Outlet
Voice Operation Voice Guidance
Kit
TYPE-1 TYPE-2
Kit