8.
Put the gap between two harness bands of the DADF
cable to the groove of the Reader Cable Cove and then
mount the Reader Cable Cover.
• 3 Screws (Use the screws removed in step 8, "In
the case of Reverse ADF" of "Removing the
Covers".)
3x
9.
CAUTION:
After completion of this procedure, proceed
to"Installing the Dehumidification Switch and Checking
the Switch" on page 1143
■ Installing the Dehumidification
Switch and Checking the Switch
NOTE:
If the Dehumidification Switch is installed, start from step
8.
1143
9. Installation