Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1046

[IPv4 setting] > [Ping Command]; and enter the IP
address.
• The IP address specified in the Host Machine is correct
if the message say "Response from the host".
• If the message say "No response from the host", check
the following.
NOTE:
When setting the address by manually input, set the
Subnet Mask by following the instruction of the
administrator.
● Checking Network Function on the Main
Controller
Check with the loopback address.
1. Select Settings/Registration > Preferences >
Network > TCP/IP Settings > IPv4 Settings > PING
command, enter the IP address "127.0.0.1" with the
numeric keypad, and then press "Start" key.
2. When "Response from the host." is displayed,
network function of the Main Controller operates
normally.
• When "No response from the host." is displayed, the
network function of the Main Controller is failed.
• Replace the Main Controller with a properly operating
one, and check the connection.
■ Operation when using uniFLOW
Online
When using uniFLOW Online*, follow the setup procedures
on the uniFLOW* Online First Steps Guide (http://www.nt-
ware.com/uFO_FS).
* China version of "uniFLOW" is called "mdsFLOW".
1024
9. Installation