Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1012

Checking before Installation
The following conditions must be satisfied for the installation.
Therefore, it is better to check the planned installation site before delivering the machine to user site.
Points to Note at Installation
CAUTION:
• Do not remove the tapes on the Toner Cartridge. Remove them in
• Do not perform installation of the Toner Cartridge until instructed.
CAUTION:
Marked portion
When tightening the screws, do not tighten them too tightly. Otherwise, there is a risk of damage and deformation of screw
holes.
Checking Power Supply
1. There must be a power outlet properly grounded and rated as indicated (+, -10%) for exclusive use by the machine.
2. Be sure to install this machine near an outlet so that the power plug can be disconnected right away in case of
emergency, and do not put anything around the power plug.
Checking the Installation Environment
1. The environment of the installation site must be in the range as shown below. Avoid installation near the faucet, water boiler,
humidifier or refrigerator.
Guaranteed range for operation/image Temperature: 10.0 to 30.0 deg C, Humidity: 20 to 80%
2. The machine must not be installed near a source of fire or in an area subject to dust or ammonium gas. If the area is exposed
to direct rays of the sun, provide curtains to the window.
3. Be sure to provide adequate ventilation of the room to keep the work environment comfortable. Room odor can be bothering
when running the machine for a long time in a poorly-ventilated room although the ozone amount generated while running
this equipment does not harm human health.
"Starting the Setup Guide" on page 1013
990
9. Installation