Attachment Of Binocular Tube Or Phototube; Insertion Of Eyepieces And Centering Telescope - Zeiss Axioskop 2 plus Operating Manual

Carl Zeiss
Fig. 2-2 Attachment of binocular tube
Fig. 2-3 Inserting the eyepieces
☞
The eyepieces W-PL 10x/23 Br. foc. and PL 10x/23 Br. foc. can be used with all tubes
(see pp. 1-6, 1-10).
2-4
START-UP
Initial start-up
2.1.2 Attachment of binocular tube or
phototube
All the binocular tubes included in the microscope
configurations listed in section 1.3 or 1.4 can
be attached to the Axioskop 2 plus / Axio-
skop 2 mot plus as described below.
• Loosen hexagonal screw (2-2/3) using the SW3
ball-headed screwdriver. Remove dust covers (2-
2/2) from the tube underside and the dovetail
mount on the stand.
• Hold the binocular tube (2-2/1) or the binocular
phototube in a slightly inclined position and
attach it to the stand mount (2-2/4). Turn the
binocular tube in the required observation
position and tighten the hexagonal screw using
the ball-headed screwdriver.
2.1.3 Insertion
centering telescope
• Remove both dust covers (2-3/1 and 4) from the
binocular tube.
• Remove both eyepieces (2-3/2) from the cases
and insert them in the binocular tube until stop.
• The centering telescope (2-3/3), which is used
to view the aperture/phase/darkfield stops and
to center phase and darkfield stops, can be
inserted in one of the tubes instead of an
eyepiece.
focusing on these stops and the setting to be
fixed using a clamping screw.
Axioskop 2 plus
Axioskop 2 mot plus
of eyepieces
The adjustable eyelens
B 40-075 e
and
permits
10/03