Documentation; Attachment Of Photomicrography Equipment - Zeiss Axioskop 2 plus Operating Manual

Axioskop 2 plus
Axioskop 2 mot plus
3.4

Documentation

3.4.1

Attachment of photomicrography equipment

The Axioskop 2 plus / Axioskop 2 mot plus equipped with a binocular phototube (3-28/5) can be
switched from observation to photomicrography (pushrod pulled out) using the pushrod (3-28/7). The
special T2 adapter 2.5x and other T2 adapters permit commercially available 35 mm SLR cameras (SLR -
Single Lens Reflex) and special microscope cameras (e.g. MC 200
the 60 mm interface camera port of the binocular phototube. For use of photomicrography equipment
please see the relevant operating instructions.
Attachment of a SLR camera
(e.g. CONTAX 167 MT)
• Screw T2 adapter (416010-0000-000, 3-28/3)
suitable for the used camera on the 2.5x
connector for T2 (456005-0000-000, 3-28/4).
• Attach camera (416181-0000-000, 3-28/2) and,
if required, cable release (416167-0000-000,
3-28/1).
• Remove dust cap (3-28/8) from the phototube
(3-28/5) and insert premounted unit A in the
phototube.
• Align unit in the required position and tighten 3
Allen screws (3-28/6).
• When artificial light color reversal film is used,
the color temperature key 3200 K (3-1/12) must
be pressed. LED lamp 9 (3-1/9) then lights up.
☞
If focusing is not to be performed
through the viewfinder of the camera,
a focusing eyepiece with photo reticle
MC 2.5x / d = 26 mm (454075-0000-
000, see p. 1-15) must be used.
☞
For detailed
cameras please see manual G 42-406
II, "35 mm
microscopes and stereomicroscopes".
B 40-075 e 02/01
OPERATION
Documentation
information on SLR
SLR cameras for
from Carl Zeiss) to be attached to
CHIP
Fig. 3-28 Attachment of SLR camera,
(e.g. Contax 167 MT)
Carl Zeiss
3-41