Setting Of The Interpupillary Distance Of The Binocular Tube; Setting Of Viewing Height; Screw In Of Objectives - Zeiss Axioskop 2 plus Operating Manual

Carl Zeiss
Fig. 2-5 Setting the interpupillary distance
of the binocular tube
Fig. 2-6 Screwing in of objectives
2-6
START-UP
Initial start-up
2.1.4 Setting
distance of the binocular tube
The eyepiece distance is matched to the user's
individual interpupillary distance by swinging the
eyepiece tubes symmetrically towards one another
(2-5/A and (2-5/B).
2.1.5

Setting of viewing height

The viewing height can be set continuously in the
range from 6 to 25° by changing the viewing
angle of the two ergotubes. Furthermore, the
binocular component of the ergotubes can be
swivelled by 180°.
2.1.6

Screw in of objectives

• Move mechanical stage with carrier to the
lower stop position.
• Remove dust caps (2-6/2) from the respective
openings in the nosepiece.
• Remove objectives (2-6/3) from case and screw
them in nosepiece (2-6/1) clockwise one by one,
starting with the lowest magnification. In the
case of the Axioskop 2 mot plus, start with
objective position No. 1 of the coded nosepiece.
☞
Make
protection caps on those nosepiece
eyes
required.
Axioskop 2 plus
Axioskop 2 mot plus
of the interpupillary
sure to use the
which are not currently
B 40-075 e
dust
10/03