IBM Aptiva Handbook page 88

,QVWDOOLQJ DGDSWHU FDUGV
Your computer provides expansion slots for PCI adapter
cards only.
Follow these steps to install an adapter card:
1.
Remove the screw that secures the expansion-slot
cover. Then, remove the expansion slot cover.
2.
Align and insert the adapter card into the adapter card
connector.
3.
Secure the card with the screw that you removed in
step 1.
8-4 Chapter 8: Adding and removing adapter cards and drives
4.
If your card has cables, connect the cable or cables
from the adapter card to the correct connection on the
system board or CD-ROM drive.
5.
Reinstall all hardware (except for the expansion-slot
cover, which cannot be reinstalled) and screws that
you removed prior to the installation of the adapter
card.
If your card has cables, connect the cable or cables from the
adapter card to the correct connection on the system board
or CD-ROM drive.
If you disconnected any cables to gain access to the adapter
card connector on the system board, reconnect the cables.