Card Connector And Jumper Information - IBM Aptiva Handbook

,GHQWLI\LQJ DGDSWHU FDUG
.4330.9478
You can install PCI adapter cards into the card connectors
on the system board. Use the following table to help you
determine the type and length of adapter cards that you can
install in the card connectors.
Adapter card
Type of adapter card you can install
connector
PCI Slot 1 PCI adapter card measuring 236 mm (9.25 in.) in
length (or less)
PCI Slot 2 PCI adapter card measuring 236 mm (9.25 in.) in
length (or less)
PCI Slot 3 PCI adapter card measuring 236 mm (9.25 in.) in
length (or less)
Refer to the section "Adding and removing adapter cards" on
page 8-3 for instructions on adding or removing cards.
6HWWLQJ D MXPSHU
When you install an adapter card, you may have to set
switches or move jumpers to make the card work properly.
Plug and Play cards normally require no changes, but other
cards might. Refer to the documentation that came with the
new hardware to determine if changes to jumper or switch
settings are required.
The following figures show how to set a jumper. Position A
shows closing pins 1-2 while position B shows closing pins
2-3. Pin 1 of a jumper is usually marked by a solid white line
beside the pin.
Qptjujpo B
Qjo 2

Card connector and jumper information

Qptjujpo C
Qjo 2
9-5