IBM Aptiva Handbook page 124

Table 4: Error codes and messages (Continued)
Error codes Error messages
1701 Hard disk(s) diagnostics fail
1762 Primary master IDE has changed
Primary slave IDE has changed
Secondary master IDE has
changed
Secondary slave IDE has changed
Primary master hard disk fail
1780
1781 Primary slave hard disk fail
1782 Secondary master hard disk fail
If any of the errors persist after performing the listed corrective actions, see "Chapter 2: HelpWare support and
Note:
services" on page 2-1 for information on obtaining service.
10-18 Chapter 10: Diagnosing and recovering from problems
Corrective actions
1.Determine if the hard disk is defined correctly in BIOS
Setup.
2.Check the hard disk drive cable/connection.
3.Check the hard disk drive.
1.Make sure the System Boot Drive parameter in the
Startup Options of BIOS Setup is not set to (Drive A only).
2.Load the default settings in Setup.
3.Insert a system diskette into the diskette drive and reboot
the system.
4.Ensure the diskette drive configuration setting in BIOS
Setup is correct.
5.Check the power to the hard disk drive.
6.Check the Diskette Drive.
1.Load the default settings in Setup.
2.Check the IDE drive jumper.
3.Check the power to the IDE drive.
4.Check the IDE cable/connection.
5.Check the IDE drive.
1.Load the default settings in Setup.
2.Check the IDE drive jumper.
3.Check the power to the IDE drive.
4.Check the IDE cable/connection.
5.Check the IDE drive.
1.Load the default settings in Setup.
2.Check the IDE drive jumper.
3.Check the power to the IDE drive.
4.Check the IDE cable/connection.
5.Check the IDE drive.