IBM Aptiva Handbook page 15

&DQDGLDQ 'HSDUWPHQW RI
&RPPXQLFDWLRQV FHUWLILFDWLRQ ODEHO
NOTICE: The Canadian Department of Communications
label identifies certified equipment. This certification means
that the equipment meets certain telecommunications
network protective, operational, and safety requirements.
The Department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it
is permissible to be connected to the facilities of the local
telecommunications company. The equipment must also be
installed using an acceptable method of connection. In some
cases, the company's inside wiring associated with a single
line individual service may be extended by means of a
certified connector assembly (telephone extension cord).
The customer should be aware that compliance with the
above conditions may not prevent degradation of service in
some situations.
Repairs to certified equipment should be made by an
authorized Canadian maintenance facility designated by the
supplier. Any repairs or alterations made by the user to this
equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to
disconnect the equipment.
Users should ensure for their own protection that the
electrical ground connections of the power utility, telephone
lines, and internal metallic water pipe system, if present, are
connected together. This precaution may be particularly
important in rural areas.
Caution: Users should not attempt to make such
connections themselves, but should contact the appropriate
electric inspection authority, or electrician, as appropriate.
NOTICE: The LOAD NUMBER (LN) assigned to each
terminal device denotes the percentage of the total load to
be connected to a telephone loop which is used by the
device, to prevent overloading. The termination on a loop
may consist of any combination of devices subject only to
the requirement that the sum of the LOAD NUMBERS of all
the devices does not exceed 100.
Étiquette d'homologation du ministère des Communications
du Canada
AVIS : L'étiquette du ministère des Communications du
Canada identifie le matériel homologué. Cette étiquette
certifie que le matériel est conforme à certaines normes de
protection, d'exploitation et de sécurité des réseaux de
télécommunications. Le ministère n'assure toutefois pas que
le matériel fonctionnera à la satisfaction de l'utilisateur.
Avant d'installer ce matériel, l'utilisateur doit s'assurer qu'il
est permis de le raccorder aux installations de l'entreprise
locale de télécommunications. Le matériel doit également
être installé en suivant une méthode acceptée de
raccordement. L'abonné ne doit pas oublier qu'il est possible
que la conformité aux conditions énoncées ci-dessus
n'empêchent pas la dégradation du service dans certaines
situations.
xv