2.5 CO Line Programming
[426] ISDN TEI Mode
Description
Assigns the Terminal Endpoint Identifier (TEI) mode on ISDN port basis.
Selection
• Port number:
KX-TD816 – 01 through 04,
KX-TD1232 – 01 through 12,
( =all ports)
• Fix 0 through 63 / Automatic
Default
All ports – Fix 0
Programming
1.
Enter 426.
Display: TEI Assign
2.
Press NEXT.
Display: Port No?->
3.
Enter a port number.
To enter a Port 01, you can also press NEXT.
Display example: #01:Fix 0
4.
Enter TEI.
To change the current entry, press CLEAR and the new number.
5.
Press STORE.
6.
To programme another port, press NEXT or PREV, or SELECT and the desired port
number.
7.
Repeat steps 4 through 6.
8.
Press END.
Conditions
• If the "Point" is selected in programme [424] ISDN Configuration, assign the fixed TEI.
If "Multipoint" is selected, assign "Automatic."
• To assign all ports to one selection, press the
the contents programmed for Port 01.
• After this assignment, you should reset the system so that this assignment is effective.
180
key at step 3. In this case, the display shows
General Programming