[Al. 09E_Network Warning] - Mitsubishi Electric Melservo-J5 MR-J5 Series User Manual

[AL. 09E_Network warning]

• Error exists in the network data reception.
• An error exists in the network setting.
[AL. 09E.2_Communication cycle setting warning]
Cause
1.
The communication cycle was set to 31.25 μs.
2.
An unsupported communication cycle was set.
[AL. 09E.3_Cyclic points warning]
Cause
1.
When setting the communication cycle of
31.25 μs, a value larger than 32 bytes was set
to the cyclic points number.
[AL. 09E.4_Parameter file warning]
Cause
1.
There is an error on the parameter file of the
parameter automatic setting.
2.
The processing of the automatic parameter
setting was interrupted.
[AL. 09E.5_Cyclic communication setting warning]
Cause
1.
The cyclic communication time setting for the
communication cycle is long.
[AL. 09E.6_IP address setting warning]
Cause
1.
Duplication of an IP address has been
detected.
[AL. 09E.7_Parameter unreflected warning]
Cause
1.
Parameter automatic setting was performed
for the parameters that require power cycling.
[AL. 09E.8_Master station error detection warning]
Cause
1.
An error was detected on the master side.
Check/action method
[G]: Set [Pr. PA01.7 High speed mode] to "1".
[WG]: Set the communication cycle to 62.5 μs or longer.
Review the setting on the master side.
Check/action method
Change the communication cycle, or review the mapping.
Check/action method
Replace the parameter automatic setting file.
Perform [AL. 086.1] check method.
Check/action method
Review the cyclic communication time on the master side.
Check/action method
To ensure that there is no duplication of IP addresses, review [Pr. NPA01 IP
address setting], [Pr. NPA02 IP address], and the rotary switch setting.
Check/action method
Cycle the power.
Check/action method
Check the status on the master side.
1 SERVO AMPLIFIER TROUBLESHOOTING
1.3 Handling methods for alarms/warnings
1
Model
[G]
[WG]
Model
[G]
Model
[G]
[WG]
Model
[G]
[WG]
Model
[G]
[WG]
Model
[G]
[WG]
Model
[G]
[WG]
71