DURKOPP ADLER 581 Operating Instructions Manual page 75

Programming
Operating Instructions 581 - 02.0 - 05/2019
Bartack forms
No bartack Taper bar
9. Confirm the selection with the
Using the button
further values (see the following list of menu items and sub-menu
items).
Or you can quit the setting mode using the
List of menu items and sub-menu items
Value Description
Length settings
Cutting length: The cutting length can be adjusted,
depending on the sewing equipment, from 6 mm to
max. 50 mm.
Eyelet diameter (only for eyelet machines)
Stitch length in the buttonhole seam: Distance from
stitch to stitch within the seam (from 0.5 mm to 2 mm).
S.p.m. in the eyelet (only for eyelet machines):
Number of evenly distributed stitches in the entire
eyelet.
Overlap in the eyelet (only for eyelet machines):
Overlap of seam beginning and seam end.
Thread cutting length: For subclass 581-112 or
581-312, you can adjust the length of needle thread
and hook thread on the underside of the buttonhole.
Stitch condensing increases the seam safety at
the seam beginning and at the seam end.
Bartack
button.
you can move one level higher and set
Round tack Eyelet
button.
73