DURKOPP ADLER 581 Operating Instructions Manual page 125

Programming
Operating Instructions 581 - 02.0 - 05/2019
3. Insert the locking peg (1) and check whether the peg is
engaged in the slot of the arm shaft.
In this position, the needle bar must be at top dead center.
4. Press the
 The following appears on the display:
Fig. 73: Looper adjust (2)
5. Remove the locking peg (1) again.
6. Press the
 The sewing motor moves into the test position 2 (looping
stroke left).
The following appears on the display:
Fig. 74: Looper adjust (3)
button.
button.
123