DURKOPP ADLER 581 Operating Instructions Manual page 66

Programming
Manual operation
In the sequence shown on the display, lines are displayed between
the buttonhole shapes. It is possible to see the currently selected
buttonhole from the bar below the number.
Fig. 44: Display for manual operation
The control does not change automatically between the
buttonhole shapes. Changes are made manually using the
buttons or .
Light barrier mode
If the light barrier kit is installed, it is possible to work in light barrier
mode.
Either the lapel or the front edge is detected by 2 light barriers,
and the corresponding program is automatically selected.
Precisely 2 programs must be entered in the sequence.
Light barrier mode can be recognized by the symbol (1).
Fig. 45: Light barrier mode
①
(1) - Symbol
64 Operating Instructions 581 - 02.0 - 05/2019