Door Hinge Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
6. Remove and retain the three screws at the bottom of the door
(see Figure 230).
Figure 230: Screws at Bottom of Door
1 Location of screws (3) at bottom of door
7. Gently lift front door panel off the door.
8. At the back side of the front door panel, at both the left and right
sides remove and retain the two hex head cap screws and
washers (see Figure 231). This will detach the endcaps from the
door assembly.
9. After removing the right and left endcaps, pull the door handle
tube out from the endcaps.
10. Replace the door handle components if needed.
11. After replacing door handle components, install the oven door and
test for proper positioning - follow all warnings and steps for
Installing the Door, page 88.
58300000156573_ARA_EN_B
Figure 231: Hex Head Cap Screws and Washers
1 Hex head cap screws and washers (4 of each) – left
side shown
4.7.9

Door Hinge Removal and Replacement

Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
When the door is removed from the range, never release locking
levers or try to close the hinges. Without the weight of the door, the
powerful springs will snap the hinges shut with great force.
Sharp Components
Wear gloves when removing the door hinge
Page 114 of 119