Removing And Installing Drives In The Internal Drive Cage - Siemens SIMATIC IPC847D Operating Instructions Manual

Expanding and assigning parameters to the device
6.5 Drives
6.5.4

Removing and installing drives in the internal drive cage

Requirement
● The device is opened.
Procedure - removing drive
1.
2.
3.
4.
Installing a drive
1.
2.
3.
4.
82
Remove the card retainer.
Remove the four screws
Then disconnect the power cable
and the data cable from the
installed drives.
Take the drive cage out of the
housing.
Push the drive into the bay from
the front.
Secure the drive with four screws
to the drive cage.
Connect the power cable and the
data cables to the drive.
Install the drive cage again.
①
.
Operating Instructions, 01/2014, A5E32997454-AA
SIMATIC IPC847D