Siemens SIMATIC IPC847D Operating Instructions Manual page 183

On-screen error messages
On-screen error message
Address conflict
Combination not supported
IO device IRQ conflict
Invalid System Configuration
Data
Allocation Error for ...
System battery is dead.
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Failure Fixed Disk
Keyboard error
Key seizure
System RAM Failed at offset:
Error - CMOS battery failed
Error - SMART failure detected
on HDD
Error - Keyboard error
No bootable device -- Please
restart system
Error - Realtime clock has lost
power
Error - Keyboard controller error
Screen remains dark - cursor
flashes at top left
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
Meaning / tip
Plug-and-play problem.
Contact your Technical Support.
Plug-and-play problem.
Contact your Technical Support.
Plug-and-play problem.
Contact your Technical Support.
Plug-and-play problem
Set the RESET CONFIGURATION DATA option in the
•
"Advanced" menu of Setup.
Contact your Technical Support.
•
Plug and Play problem
Undo the last hardware change.
•
Contact your Technical Support.
•
The battery on the CPU module is defective or dead.
Contact your technical support team.
Call SETUP, adjust and then save the settings. Contact Technical
Support if this message persists in further retries to startup the
system.
HDD access error.
Check the configuration in SETUP.
Contact Technical Support.
Check whether the keyboard is properly connected.
Check whether a key on the keyboard has seized.
Memory error.
Contact Technical Support.
The battery on the CPU module is defective or dead.
Contact your technical support team.
Hard disk fault: A fault threshold specified by the manufacturer has
been exceeded. Operation of the hard disk is unreliable. The hard
disk has to be replaced. Contact your Technical Support.
Check whether the keyboard is properly connected.
Possible causes:
No operating system installed
•
Wrong drive addressed (disk in drive A/B)
•
Incorrect active boot partition
•
Incorrect drive entries in SETUP
•
HDD not connected / defective
•
Clock chip error.
Contact Technical Support.
Keyboard error.
Contact Technical Support.
A data carrier is inserted in the ODD drive. In this case it can take
several minutes until the BIOS power up is continued.
Technical specifications
8.6 BIOS description
183