Siemens SIMATIC IPC847D Operating Instructions Manual page 57

Procedure
NOTICE
Damage to the hard disk and loss of data
When you remove the hard disk while data is being written to the hard disk, you may
damage the hard disk and destroy data.
• Only remove the hard disk tray from the removable drive bay when the hard disk is
• Observe the EGB guidelines.
1. Identify which hard disk the RAID controller has reported as being faulty.
2. Open the front panel.
3. Slide the cover
4. Open the lock with the appropriate key.
5. Fold out the tray bracket somewhat to the front and pull out the hard disk tray by the tray
6. Insert the new hard disk tray into the removable drive bay and push it all the way in.
7. Fold back the tray bracket until it rests completely against the hard disk tray.
8. Slide the cover of the removable drive bay lock to the left.
9. Lock it with the appropriate key.
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
inactive. Inactive means the hard disk status display of the removable drive bay is not
flashing.
①
of the removable drive bay lock to the right.
The marked lock is exposed.
bracket.
The procedure is described in more detail in the section "Removing and installing drives
in the front drive cage (Page 79)".
The power supply LED
Note
Always lock the hard disk tray in the removable drive bay to ensure reliable operation of a
device with removable drive bay.
②
must be on.
Commissioning the device
4.4 Notes on different device configurations
57