Removing And Installing The Drive In The Fixed Hard Disk Bay - Siemens SIMATIC IPC847D Operating Instructions Manual

6.5.5

Removing and installing the drive in the fixed hard disk bay

Requirement
● The device is opened.
Procedure - installing a drive
1.
2.
Removing drives
1.
2.
See also
Open the device. (Page 69)
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
① ②
Hold the drive or
drive carrier plate and fasten it
③
with four screws or
Connect the power cable and the
data cables to the drive.
Disconnect the power cable and the data cables from the drive.
Loosen the four screws
Expanding and assigning parameters to the device
onto the
④
.
③ ④
or and remove the drive from the housing.
6.5 Drives
83