Removing And Installing Drive Fans - Siemens SIMATIC IPC847D Operating Instructions Manual

Expanding and assigning parameters to the device
6.5 Drives
6.5.2

Removing and installing drive fans

Requirement
● The device is opened.
Note
Install only a fan of the same type. Information about the original spare parts for SIMATIC
PCs is available in the Internet at After-sales information system for SIMATIC PC/PG
(http://www.siemens.com/asis).
Install the drive fan as seen in the figure. The drive fan blows cooling air into the housing.
Procedure
1. Press on the clip
2. Remove the drive fan
3. To install the drive fan once again,
4. Slide the drive fan slightly tilted
Removing the adapter plug
If necessary, remove the adapter plug, for example, when removing the drive cage.
1. To do so, press on the clips
78
①
at the small
power supply plug and pull the plug
to the top from the larger adapter
plug.
②
(arrow).
slide the power supply plug
the adapter plug until it snaps into
place.
forward down onto its retainer
Make sure that the fan carrier does
not extend beyond the housing.
Now the fan is correctly installed.
the side of the adapter plug and
remove the plug by pulling it down.
to the top
①
into
③
.
①
on
Operating Instructions, 01/2014, A5E32997454-AA
SIMATIC IPC847D