Expanding and assigning parameters to the device
6.2 Open the device.
Limitation of liability
All technical data and approvals apply only to expansion units which are released by
SIEMENS.
Siemens does not accept any liability for impairment of functions caused by the use of third-
party devices or components.
Observe the installation instructions for the components. UL approval of the device only
applies when the UL-approved components are used according to their "Conditions of
Acceptability".
Procedure
1. Open the front panel.
2. Loosen the indicated screw.
3. Push the cover to the back and
Closing the device
Proceed in reverse order.
70
The screw stays captive in the
housing.
remove it pulling up.
Operating Instructions, 01/2014, A5E32997454-AA
SIMATIC IPC847D