Replacing The Redundant Power Supply Completely - Siemens SIMATIC IPC847D Operating Instructions Manual

7.4.5

Replacing the redundant power supply completely

Requirement
● The device is opened.
● Screwdriver T10
Procedure
1. Remove all the modules as
2. Disconnect the power cable of the
3. Remove the cable ties securing the
4. Loosen the Torx screw T10
5. Remove the six Torx screws T10
6. Slide the power supply toward the
7. Lift the power supply out of the
8. To install the new power supply,
SIMATIC IPC847D
Operating Instructions, 01/2014, A5E32997454-AA
described above from the power
supply.
drives and of the motherboard.
power cables in the housing.
the inside of the device.
from the rear panel.
front drive cage until the screw head
is positioned freely in the keyhole.
housing.
carry out the same steps in the
reverse order.
①
on
②
Device maintenance and repair
7.4 Installing and removing hardware
101