Siemens SIMATIC IPC847D Operating Instructions Manual page 126

Technical specifications
8.4 Technical data
General specifications
USB
PROFIBUS (optional)
PROFINET
Ethernet
Audio
- Microphone
- Line out / Headset
Status displays (LEDs)
*
1
2
3
4
5
6
126
Rear panel
Front panel
Internal
4
4
3
Electrical isolation within the safety extra-low voltage circuit (SELV)
Mechanical interference must be safely excluded within the burning operation.
Restrictions of HDD mounting on the side panel:
When mounting the device on telescopic rails, the values 10 to 58 Hz: 0.019 mm, 58 to
200 Hz: 3 m/s may not be exceeded. Vibrations may not exceed 200 Hz.
2
Restrictions when HDDs are mounted in removable drive bays:
mechanical stress must be safely excluded.
See section "Status displays"
For unique labeling, the LAN interfaces are numbered on the enclosure. The numbering
by the operating system may deviate from this.
Interfaces supplied as optional.
AMT and teaming cannot be used simultaneously on the Ethernet interface.
× USB 3.0 high current
2 × USB 2.0 high current
1 × USB 3.0 high current
1 × USB 2.0 high current
1 × USB 3.0 devices high current
9-pin D-sub socket, CP5622-compatible, 9.6 Kbps to 12
Mbps, programmable with software:
DP master: DP-V0, DP-V1 with SOFTNET DP
DP slave: DP-V0, DP-V1 with SOFTNET-DP slave
RS 485 electrically isolated (SELV circuit)*
3 × RJ45 interface, CP 1616 compatible onboard interface
based on ERTEC 400, 10/100 Mbps electrically isolated *
2 × Ethernet interface (RJ-45), Wake on LAN, Remote Boot
and teaming are supported.
10/100/1000 Mbps, electrically isolated *
Ethernet 1: WGI217LM, AMT-capable
frames up to 9014 bytes
Ethernet 2: Intel WGI210IT, supports jumbo frames up to
9014 bytes
IDT 92HD81HD
2 × 0.5 W / 8 Ohm
Operating Instructions, 01/2014, A5E32997454-AA
, supports jumbo
6
SIMATIC IPC847D