Mitsubishi Melsec-L Series User Manual page 69

6 - 24
Current
Item
value
When linked
CH SIO 1 (ON)
operation setting
CH PRO. 1 (ON)
When
CH P/S 1 (ON)
independent
operation setting
CH C/N 1 (ON)
CH NEU. 1 (ON) Test completed
CH1: RAM error
CH ERR. 1 (ON)
CH2: ROM error
Setting
station Error Out of the setting station number range
number
1 When an error occurs even after performing the test again, consult your local
Mitsubishi service center or representative.
Status
Transmission setting
error
Protocol setting error
Transmission setting
error
Protocol setting error
6 SETTING AND WIRING
Corrective action
Check the set values (refer to
Section 7.3) and perform the
test again. ( 1)
-
Check the module installation
status and perform the test
again. ( 1)
Check the set values (refer to
Section 7.3.4) and perform the
test again. ( 1)
6 - 24