Mitsubishi Melsec-L Series User Manual page 103

[Setting description]
(1) Interrupt Pointer Start No. : PLC Side
(2) Interrupt Pointer Count : PLC Side
(3) Start I/O No. : Intelligent Module Side
(4) Start SI No. : Intelligent Module Side
7 - 28
Set the start number of the interrupt pointer (Ixx) for use in the sequence program.
The setting range is from 50 to 255.
Set the number of units of interrupt pointers (I) for use in the sequence program.
Set the start I/O No. for the C24.
1) Assign control numbers (SI) on the C24 side to the interrupt pointers (Ixx)
used in the sequence program.
2) Set the start SI No. of the interrupt control numbers.
3) The interfaces for data reception corresponding to the interrupt control
numbers are as follows:
SI No.0: for interface on the CH1 side
SI No.1: for interface on the CH2 side
7 SETTINGS FOR THE C24
7 - 28