Dump Utility Messages - IBM RT PC Problem Determination Manual

D um p U tility M essa g es
The messages for the dump utility are displayed on the two-digit
display. These messages tell you when the dump is complete, when
a dump diskette is needed, and if there is a problem found while
running the dump utility.
The messages and descriptions are:
cO The dump utility completed.
c4 There is a problem with the dump or with the diskette device
driver. Make sure you are using a formatted diskette. If the
dump does not run, go to
and test the diskette drive.
Guide
c5 The diskette is damaged. Insert another diskette in diskette
drive A.
c6 The system is requesting a VRM dump. Press the key
sequence to start the VRM dump, or press CTRL-ALT-PAUSE
to restart the system.
The characters c6 flash alternatively with a number
number is from 01 to 27, look at message 032-
messages book. For example, if 25 flashes on the system unit,
look at message 032-125.
c7 The dump diskette is full. Insert another dump diskette in
diskette drive A.
c8 The system is checking the dump diskette for damage.
c9 The dump utility is running.
IB M R T Problem Determination
lxx
Section 2. The Dump Utilities 2-17
If this
xx.
in the