Chapter 7. Using The Neocenter Utility; Establishing Communication With Your Host; Setting Ip Addresses - IBM 4560SLX User Manual

Chapter 7. Using the NeoCenter utility

The NeoCenter utility enables you to configure the unit using the Windows
interface. The utility enables you to perform the following tasks:
v Establishing communication with your host
v Setting IP addresses
v Setting an access password
v Setting SNMP traps
v Setting e-mail addresses
v Setting remote FTP server parameters
v Setting SCSI parameters
v Setting the SCSI identification
v Setting library parameters
v Setting the drives
v Uploading data
v Downloading data
v Rebooting the library

Establishing communication with your host

To establish communication with your host, complete the following procedure:
1. Turn on the power.
2. Connect the RJ11-DB9 cable between the connector labeled RS232 on the library
3. Power up the host computer and boot into Windows. Windows 95, Windows
4. Install the configuration utility from the included 3.5" diskette (A:\SETUP).
5. Launch the configuration utility. The Main screen is displayed.
6. Click Connect.
7. Verify settings of the COM port and click OK.
Note: If the connection is not successful, check all cable connections and repeat

Setting IP addresses

To set IP addresses, complete the following procedure:
Note: Configuration addresses are network specific. Contact your network system
1. Establish communications with the library, if not already established.
2. On the Main screen, select Configure.
© Copyright IBM Corp. 2002
and a COM port on the host computer. Note the port you select.
98, Windows 2000, or Windows NT
The Serial Port Setting screen is displayed.
step 6 and step 7. If communication with the library fails again, contact IBM
Technical Support.
administrator for the appropriate values. These settings enable access to
your library from your network and the World Wide Web.
Get other manuals https://www.bkmanuals.com
®
4.0 are supported.
®
55