IBM RT PC Problem Determination Manual page 324

B-26 AIX Operating System Problem Determination Guide
Verify that both the local and remote sites are
using the same file transfer protocol and that
the remote site is set up to send. Then select
receive and try the file transfer again.
Module_ID = ATE RC = 8
The session has been disconnected because the
system can no longer detect a carrier signal.
A break in the connection may have occurred
because of one of the following:
• The telephone line has problems.
• The remote system went out of operation.
• One of the modems became disconnected.
• A wire has come loose.
Attempt to reestablish the connection.
Module-ID = ATE RC = 9
The receive routine logs this error during and
XMODEM file transfer when the checksum
value it calculates for the sector just received
does not match the checksum value calculated
and sent by the remote site. This error usually
occurs because of noise on the transmission
line.
No action is necessary. The sector is
automatically requested again up to nine times.
If the errors prevent the file transfer from
continuing and you are using a telephone
connection, try terminating the current session
and establishing a new connection that may be
less noisy.
Module-ID = ATE RC = 10
The receive routine logs this error during an
XMODEM file transfer when the same sector is
received twice.