B0046991 / Rev. 1.6
Cable shields must be connected according to the wiring diagram (For details refer to chapter 5.4)
and should have no additional connections.
Instruction: Leading a cable through EMC gland
•
Remove outer PVC sheath and shield but leave enough length for sheath and leads.
•
Circular cut of outer PVC sheath after about 20 mm, but do not remove
•
Move cable through the gland
•
Remove outer sheath
•
Pull cable back until the shield and the contact springs inside the PG-gland connect.
•
Close PG-gland
Fig. 8: Connecting cable to PC-gland
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R1000 series E20
Damaged cable isolation can cause further (unwanted) electrical
Note
connections.
Kabelabschirmung
Cable shield
Manual
20mm
Technical data
23