Roland R1000 Series Manual page 110

Start-up
System parameter 4: Adjusting the measuring mode.
system param.
mode: ext.cont.
Fig.. 57: Adjusting the measuring mode
Possible measurement modes:
•
External continuous measurement:
The system executes measurements, as long as the "Measurement start" signal is applied
via the external PLC input. The repetition rate of the measurement depends on the type of
sensor: 0.5 seconds for P42, P30, P42A, P75V; 1 second for P36; 2 seconds for P75.
•
External single measuring:
The system measures once if the "Measurement start" signal is applied via the external PLC
input. Each measurement must initiated separately. The hints in chapter 6.1.4.1 „timing
diagram single measurement" must be abided by.
•
Demo mode:
This mode of operation is intended for equipment demonstrations, but not for normal process
operation. The system executes measurements continuously. The repetition rate of the
measurement depends on the type of sensor: 1 second for P42, P30, P42A, P75V;
2 seconds for P36; 4 seconds for P75.
System parameter 5: Adjusting the baud rate of the serial RS232 interface (for C version only).
system param.
baud rate:
Fig.. 58: Adjusting the baud rate
According to the requirements of the super-ordinated system, values from 300 – 19200 can be set.
System parameter 6: Deleting all measuring programs.
system param.
CLR param.:
Fig.. 59: Deleting of measuring programs
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
110
Double Sheet Detector R1000 series E20
4
5
9600
6
no
The deletion cannot be undone.
Attention
Manual
B0046991 / Rev. 1.6