Inspect The Electrical Wiring; Inspect The Tires And Wheels (Including Lug Nut Torque) - Genie S-65 Service Manual

Service Manual - Second Edition
800-610-4101
ActionRental.com
B-7

Inspect the Electrical Wiring

Maintaining electrical wiring in good condition is
essential to safe operation and good machine
performance. Failure to find and replace burnt,
chafed, corroded or pinched wires could result in
unsafe operating conditions and may cause
component damage.
Electrocution hazard. Contact with
hot or live circuits may result in
death or serious injury. Remove all
rings, watches and other jewelry.
1 Inspect the following areas for burnt, chafed,
corroded and loose wires:
· Engine compartment electrical panel
(Gasoline/LPG models)
· Engine wiring harness
· Inside of the ground control box
· Turntable manifold wiring
2 Start the engine from the ground controls and
raise the boom above the turntable covers.
3 Inspect the turntable area for burnt, chafed and
pinched cables.
4 Lower the boom into the stowed position and
turn the engine off.
5 Inspect the following areas for burnt, chafed,
corroded, pinched and loose wires:
· Cable track on the boom
· Boom to platform cable harness
· Inside of the platform control box
· Jib boom cable cover (S-65 models)
Part No. 48412
Section 4 - Scheduled Maintenance Procedures
B-8
Inspect the Tires and Wheels
(including lug nut torque)
Maintaining the tires and wheels in good
condition is essential to safe operation and good
performance. Tire and/or wheel failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fashion.
1 Check all tire treads and sidewalls for cuts,
cracks, punctures and unusual wear.
2 Check each wheel for damage, bends and
cracked welds.
3 Check each lug nut for proper torque.
4 Check the pressure in each air-filled tire.
Tires and wheels
Tire size
Tire ply rating
Tire pressure
Wheel lugs
Lug nut torque, dry
Lug nut torque, lubricated
Genie S-60 & Genie S-65
TABLE B PROCEDURES
An over-inflated tire can
explode and may cause death
or serious injury.
Tip-over hazard. Do not use
temporary flat tire repair products.
15-19.5 NHS
10 @
12
85 psi
5.86 bar
3
/ -16
4
420 ft-lbs
569.5 Nm
320 ft-lbs
433.9 Nm
4 - 17